Engine

Intake Manifold

~3min read
010203040502518N·mlb·ft
Tightening torque found on this page

Exploded View

Intake manifold Manifold absolute pressure sensor Gasket
Electric throttle control actuator Water hose 1 Clamp
Water hose 2 EVAP hose 1 EVAP canister purge volume control solenoid valve
EVAP hose 2 EVAP resonator EVAP hose 3
Bracket 1 Bracket 2 Gasket (bank 2)
Gasket (bank 1)
To multi-way control valve. Refer to MULTI-WAY CONTROL VALVE : Exploded View. To turbocharger assembly (bank 2). Refer to Exploded View. To EVAP canister. Refer to EVAP CANISTER : Exploded View.
Comply with the assembly procedure when tightening. Refer to Removal and Installation.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
: Indicates that the parts is connected at points with same symbols in actual vehicle.

Removal and Installation

REMOVAL

Remove engine cover. Refer to Removal and Installation.

Remove air inlet tube (1 and 2). Refer to Removal & Installation.

Remove electric throttle control actuator as follows:Drain engine coolant from radiator or attach plug to prevent engine coolant leakage when engine coolant is not drained. Refer to ENGINE COOLANT : Draining.

Disconnect water hoses from electric throttle control actuator. When engine coolant is not drained from radiator, attach plug to water hoses to prevent engine coolant leakage. Disconnect electric throttle control actuator harness connector. Loosen mounting bolts in the order from 4 to 1 as shown in the figure.
Remove gasket.

Disconnect blow-by hose 1 (bank 1) and blow-by hose 2 (bank 1) and EVAP hose 1 from intake manifold.

Remove EVAP canister purge volume control solenoid valve harness connector.

Remove EVAP resonator and bracket 2.

Disconnect the manifold absolute pressure sensor harness connector.

Remove blow-by hose 1 (bank 1) and blow-by hose 2 (bank 1).

Loosen mounting bolts in the order from 8 to 1 as shown in the figure to remove intake manifold.

: Engine front

Remove gasket (bank 1 and bank 2).

Remove following parts, if necessary.

  • Manifold absolute pressure sensor

  • EVAP canister purge volume control solenoid valve

INSTALLATION

Note the following, and install in the reverse order of removal.

Intake Manifold

  • Tighten mounting bolts to the torque specified below in the order from 1 to 8 as shown in the figure.

    : 25 N·m
    : Engine front

Electric Throttle Control Actuator

  • Tighten to the torque specified below in the order from 1 to 4 as shown in the figure.

    : 9 N·m
  • Perform the “Idle Air Volume Learning” and “Throttle Valve Closed Position Learning” when harness connector of electric throttle control actuator is disconnected.

    • Idle Air Volume Learning: Refer to Work Procedure.

    • Throttle Valve Closed Position Learning: Refer to Work Procedure.

Inspection

INSPECTION AFTER REMOVAL

Surface Distortion

  • Check the surface distortion of the intake manifold mating surface with a straightedge (A) and a feeler gauge (B) (commercial service tool).

    Limit : Refer to Intake Manifold.
  • If it exceeds the limit, replace intake manifold.