Engine
Rear Oil Seal
In this manual: Engine
~1min read
Removal & Installation
REMOVAL
Remove transmission assembly, refer to the following:
2WD models: Refer to Removal and Installation.
4WD models: Refer to Removal and Installation.
Remove drive plate. Refer to Removal and Installation.
Remove rear oil seal with a suitable tool.

INSTALLATION
Install rear oil seal.
Install rear oil seal so that each seal lip is oriented as shown in the figure.

| : Oil seal lip | |
| : Dust seal lip | |
| : Engine inside | |
| : Engine outside |
Press in rear oil seal (1) to the position as shown in the figure.

| : Cylinder block rear end face | |
| : 0 - 0.5 mm (0 - 0.020 in) |
Using a suitable drift (A), press-fit until the height of rear oil seal is level with the mounting surface.

Suitable drift: outer diameter 100 mm (3.94 in), inner diameter 85 mm (3.35 in).
Install in the reverse order of removal after this step.
Was this page helpful?