Electric Parking Brake Switch
Components
COMPONENTS
ILLUSTRATION
*1 |
ELECTRIC PARKING BRAKE SWITCH ASSEMBLY |
- |
- |
Inspection
INSPECTION
PROCEDURE
1. INSPECT ELECTRIC PARKING BRAKE SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the electric parking brake switch assembly. |
|
(b) Check the Illumination.
(1) Apply auxiliary battery voltage to the electric parking brake switch assembly and check that the switch illuminates. OK:
If the result is not as specified, replace the electric parking brake switch assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Engage the claw to install the electric parking brake switch assembly with the 4 screws. |
|
(b) Engage the guide and clamp.
2. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Click here ![]()
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
Click here ![]()
2. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Click here ![]()
3. REMOVE ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Disengage the clamp and guide. |
|
(b) Remove the 4 screws and electric parking brake switch assembly.



