Steering Angle Sensor
Components
COMPONENTS
ILLUSTRATION
*A |
w/o Heated Steering Wheel System |
*B |
w/ Heated Steering Wheel System |
*1 |
STEERING SENSOR |
*2 |
SPIRAL CABLE SUB-ASSEMBLY |
Installation
INSTALLATION
NOTICE:
A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.
PROCEDURE
1. INSPECT SPIRAL CABLE SUB-ASSEMBLY
Click here ![]()
2. INSTALL STEERING SENSOR
(a) Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly. NOTICE:
|
|
(b) Remove the lock pin from the steering sensor. |
![]() |
3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during steering sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model:)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Auxiliary battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent Clearance Sonar System* |
|||
Lighting System (for HV Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic View Monitor System |
|||
Replacement of steering sensor |
Steering angle zero point learning (Initialize intelligent clearance sonar system) |
|
|
|
Parking Assist Monitor System |
for Initialization: for Calibration: |
|
Steering angle zero point learning (Initialize panoramic view monitor system) |
Panoramic View Monitor System |
for Initialization: for Calibration: |
|
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent Clearance Sonar System* |
|||
Lighting System (for Gasoline Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic View Monitor System |
|||
Replacement of steering sensor |
Steering angle zero point learning (Initialize intelligent clearance sonar system) |
|
|
|
Parking Assist Monitor System |
for Initialization: for Calibration: |
|
Steering angle zero point learning (Initialize panoramic view monitor system) |
Panoramic View Monitor System |
for Initialization: for Calibration: |
|
PROCEDURE
1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here ![]()
2. REMOVE STEERING SENSOR
(a) Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly. NOTICE: Do not damage the claws and pins of the spiral cable sub-assembly. |
![]() |



