Vsc Off Switch
Components
COMPONENTS
ILLUSTRATION
*1 |
COWL SIDE TRIM SUB-ASSEMBLY LH |
*2 |
FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
*3 |
FRONT DOOR SCUFF PLATE LH |
*4 |
HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
*5 |
INSTRUMENT SIDE PANEL LH |
*6 |
NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
*7 |
NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
*8 |
VSC OFF SWITCH |
Inspection
INSPECTION
PROCEDURE
1. INSPECT VSC OFF SWITCH
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector. OK: The connector is securely connected. |
|
(b) Disconnect the VSC OFF switch connector.
(c) Check both the connector case and the terminal for deformation and corrosion.
OK:
No deformation or corrosion.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
5 (+) - 2 (E) |
Switch pushed |
Below 1 Ω |
5 (+) - 2 (E) |
Switch not pushed |
10 kΩ or higher |
HINT:
If the result is not as specified, replace the VSC OFF switch.
Installation
INSTALLATION
PROCEDURE
1. INSTALL VSC OFF SWITCH
(a) Engage the 2 claws to install the VSC OFF switch to the No. 1 instrument panel sub-assembly.
2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here ![]()
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here ![]()
4. INSTALL INSTRUMENT SIDE PANEL LH
Click here ![]()
5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here ![]()
6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here ![]()
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here ![]()
8. INSTALL FRONT DOOR SCUFF PLATE LH
Click here ![]()
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here ![]()
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here ![]()
3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here ![]()
4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here ![]()
5. REMOVE INSTRUMENT SIDE PANEL LH
Click here ![]()
6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here ![]()
7. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here ![]()
8. REMOVE VSC OFF SWITCH
(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the VSC OFF switch from the No. 1 instrument panel sub-assembly. |
|

