Data List / Active Test
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not determine whether a part is faulty based only on these reference values.
HINT:
The Techstream Data List allows you to read the values or status of switches, sensors, actuators and other components without removing any parts. This non-intrusive check can be very useful, since intermittent conditions or signals can be identified before parts or wiring are moved. Reading the Data List during troubleshooting saves time in diagnosis.
DATA LIST
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn on the Techstream.
(d) Select the following menus: Body Electrical / Central Gateway / Data List.
Body Electrical > Central Gateway > Data ListTester display |
|---|
IG2 SW |
IG1 SW |
ACC SW |
+B Voltage |
Number of DTC |
(e) Record the Data List.
Body Electrical > Central Gateway > Data ListTester display | Item | Range | Normal Condition |
|---|---|---|---|
IG2 SW |
Ignition switch ON signal (IG2 terminal) |
OFF or ON |
OFF: Ignition switch in ACC or OFF ON: Ignition switch in ON position |
IG1 SW |
Ignition switch ON signal (IG1 terminal) |
OFF or ON |
OFF: Ignition switch in ACC or OFF ON: Ignition switch in ON position |
ACC SW |
Ignition switch ACC signal (ACC terminal) |
OFF or ON |
OFF: Ignition switch in OFF position ON: Ignition switch in ACC or ON position |
+B Voltage |
Battery voltage (BATT terminal) |
8 V or more, or less than 8 V |
More than 8 V: Battery voltage is 8 V or more Less than 8 V: Battery voltage is less than 8 V |
Number of DTC |
Number of DTCs |
0 à 255 |
0: Normal |