Network Operation
ECU malfunction (B1003)
In this manual: Network Operation
~1min read
DESCRIPTION
DTC No. | Detection Item | DTC Detection Condition | Suspected Area | Note |
|---|---|---|---|---|
B1003 |
ECU malfunction |
A malfunction in the non-volatile memory of the central access gateway ECU (network access gateway ECU) is detected. |
Central Gateway ECU (Network Gateway ECU) |
- |
PROCEDURE
CONFIRM THE DTC OUTPUT AGAIN
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn on the Techstream.
(d) Select the following menus: Body Electrical / Central Gateway / Trouble Codes.
Body Electrical > Central Gateway > Trouble CodesResult:
Result | Proceed to |
|---|---|
DTC B1003 is not output by the central access gateway ECU (network access gateway ECU). |
A |
DTC B1003 is output by the central gateway ECU (network gateway ECU) |
B |
| A | USE SIMULATION METHOD TO CHECK |
| B | REPLACE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) |
Was this page helpful?