Network Operation

Communication stop mode of the ECM

~4min read

DESCRIPTION

Detection Item

Symptom

Suspected Area

Communication stop mode of the ECM

One or more of the following conditions are met:

  • The communication stop for "ECM (Engine)" is displayed on the "Communication Bus Check" screen of the Techstream.

    Click here

  • The communication stop history for "ECM (Engine)" is displayed on the "Communication Bus Check (Detail)" screen of the Techstream. (The lost communication duration value for "ECM (Engine)" is 6 or more.)

    Click here

  • Communication system DTCs (DTCs beginning with U) corresponding to "ECM communication stop mode" in the "DTC combination table" are output.

    Click here

  • Main line or ECM connector
  • Branch line or ECM connector
  • ECM power source circuit
  • ECM ground circuit
  • ECM

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • Because the diagnostic sequence is important for accurate diagnosis, be sure to perform troubleshooting using the section "How to Use Troubleshooting" when CAN communication system DTCs are output.

    Click here

  • Before measuring the CAN bus resistance, turn the ignition switch OFF and leave the vehicle for at least 1 minute without using the key or switches, and without opening or closing any doors. Then disconnect the cable from the negative (-) battery terminal and leave the vehicle for at least 1 minute before measuring the resistance.
  • After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

    Click here

  • After completing repairs, perform the DTC check procedure and make sure the DTCs are not output again.

    DTC check procedure: Turn the blind spot monitor system ON using the blind spot monitor main switch (ON/OFF switch), turn the cruise control main switch ON, turn the LDA main switch ON, then drive the vehicle at a speed of approximately 60 km/h for approximately 5 minutes.

  • After repair, perform the CAN bus check and make sure all ECUs and sensors connected to the CAN communication system are displayed as normal.

    Click here

  • Check the fuses for the circuits related to this system before performing the following procedure.
  • Before replacing the ECM, refer to the registration section.*1

    Click here

  • *1: with Smart Key System

HINT:

  • Before disconnecting the related connectors for inspection, press on the body of each connector to make sure the connector is not loose or disconnected.
  • When a connector is disconnected, make sure the terminals and connector body are not cracked, deformed or corroded.

PROCEDURE

  1. CHECK FOR OPEN CIRCUIT IN CAN BUS LINES (ECM MAIN LINE)

(a) Disconnect the cable from the negative (-) battery terminal.

(b) Disconnect the ECM connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

A38-13 (CANH) - A38-26 (CANL)

Cable disconnected from negative (-) battery terminal

108 à 132 Ω

*a

Front view of wire harness side connector

(to ECM)

NG

REPAIR OR REPLACE CAN BUS MAIN LINES OR CONNECTOR (ECM)

OK
  1. CHECK ECM POWER SOURCE CIRCUIT

(a) Check the ECM power source circuit.

  • with fuel vapor pump module: Click here
  • without fuel vapor pump module: Click here
OK

REPLACE ECM

NG

REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)