Honda Accord Quiz
Engine Control

Evaporative Emission (EVAP) System - Component Replacement

In this manual: Engine Control
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

Charcoal Canister
PROCEDURE

1. Disconnect all vent hoses from the canister assembly, remove the bolts, and remove the assembly from under the vehicle. Make sure all disconnected hoses are properly labeled.
2. Installation is the reverse of removal.
Two-way EVAP valve, canister purge valve, fuel tank pressure sensor and EVAP bypass solenoid valve
3. To gain access to these valves/sensors, remove the charcoal canister, then remove each component individually.
4. Installation is the reverse of removal.
Canister Purge Solenoid Valve
5. Disconnect the vacuum hoses from the canister purge solenoid valve.
6. Remove the mounting bolt and remove the valve from the engine compartment.
7. Installation is the reverse of removal.

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.