Adjustment of Starter Interlock Switch (Transaxle Selector Switch) and Transaxle Control Cable

1. Set the transaxle selector lever to "N".

2. Loosen the adjusting nut securing the transaxle control cable to the manual control lever.

3. Set the manual control lever to the neutral position ("N").

4. Loosen the bolts securing the starter interlock switch (transaxle selector switch) and rotate its body so that the hole in the switch body flange aligns with the hole at the end of the manual control lever (see section A-A in the figure).

5. Without changing the position of the starter interlock switch (transaxle selector switch), tighten its mounting bolts to the specified torque.

6. Lightly tension the cable connecting the transaxle selector lever to the control valve body in the direction indicated by the arrow in the figure, then tighten the adjusting nut.

7. Check that the transaxle selector lever is in the "N" position.

8. Check that the gears engaged correspond to each position of the transaxle selector lever, and that the transaxle operates normally in each range.