Hyundai Elantra CN7 Quiz

Adjusting Differential Case Preload (DIFFERENTIAL CASE PRELOAD)

In this manual: Adjusting Differential Case Preload (DIFFERENTIAL CASE PRELOAD)
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read

Place a piece of soft solder (approximately 10 mm long and 3 mm in diameter) on the torque converter housing, as shown in the illustration.

Установите картер гидротрансформатора на картер КПП без использования герметика.

Install the torque converter housing onto the transaxle case without sealant. Tighten the mounting bolts to the specified torque. Loosen the mounting bolts and remove the solder. Using a micrometer, measure the thickness "T" of the compressed solder. To obtain the specified preload, select a spacer with a thickness within the specified range.

Specification: 0.045 – 0.105 mm. Spacer thickness = (solder thickness "T") + (specified preload)

Схема гидравлической части системы управления АКПП

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.