Hyundai Elantra CN7 Quiz

Neutral Start Switch (A/T Selector Lever Switch) Adjustment

In this manual: Neutral Start Switch (A/T Selector Lever Switch) Adjustment
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
01020304050129N·mlb·ft
Tightening torque found on this page

1. Move the selector lever to the "N" (neutral) position.

2. Ослабьте контргайку крепления троса управления АКПП к рычагу ручного управления

2. Loosen the lock nut securing the A/T control cable to the manual control lever.

3. Move the manual control lever to the "N" (neutral) position.

4. Loosen the neutral start switch mounting bolts and rotate the switch body so that the hole in the 12 mm end of the manual control lever aligns with the hole in the 12 mm flange of the switch body.

5. Tighten the switch mounting bolts to the specified torque, making sure the switch position does not change.

Tightening torque, neutral start switch mounting bolt:

10 - 12 N·m

Be careful when adjusting the neutral start switch position not to drop the O-ring from the switch body.

Tighten the switch mounting bolts carefully.

6. Проверьте, что рычаг селектора АКПП находится в положении "N" (нейтральное

6. Check that the A/T selector lever is in the "N" (neutral) position.

7. Adjust the AT control cable tension with the flanged lock nut so that the cable is slightly taut. Then check that the AT shift lever moves smoothly.

8. Выполните дорожное испытание и проверьте соответствие включаемых диапазонов

8. Perform a road test. Check that the correct range is engaged in each AT shift lever position and that the transmission operates normally in each range.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.