Integrated Memory Seat (IMS)
Components and Component Location
Components
Connector Pin Information
| No | Connector A | Connector B | Connector C |
| 1 | Cushion Extension Motor (Front) | Battery (+) | Slide Switch (Front) |
| 2 | Tilt Motor (Front) | Ground | Tilt Switch (Front) |
| 3 | Rear Height Motor (Up) | Battery (+) | Front Tilt Switch (Up) |
| 4 | Slide Motor (Front) | - | Rear Height Switch (Up) |
| 5 | Cushion Extension Motor (Rear) | Ground | Cushion Extension Switch (Front) |
| 6 | Tilt Motor (Rear) | B-CAN (High) | |
| 7 | Front Tilt Motor (Up) | B-CAN (Low) | |
| 8 | Front Tilt Motor (DOWN) | - | |
| 9 | Rear Height Motor (Down) | - | |
| 10 | Slide Motor (Rear) | Slide Hall Sensor | |
| 11 | Front Tilt Hall Sensor | ||
| 12 | - | ||
| 13 | Seat Position Sensor Power | ||
| 14 | IGN1 | ||
| 15 | Slide Switch (Rear) | ||
| 16 | Tilt Switch (Rear) | ||
| 17 | Front Tilt Switch (Down) | ||
| 18 | Rear Height Switch (Down) | ||
| 19 | Cushion Extension Switch (Rear) | ||
| 20 | Ground | ||
| 21 | - | ||
| 22 | - | ||
| 23 | - | ||
| 24 | Tilt Hall Sensor | ||
| 25 | Rear Height Hall Sensor | ||
| 26 | Cushion Extension Hall Sensor | ||
| 27 | - | ||
| 28 | Battery (+) |
Circuit Diagrams
Wiring Diagram
Repair Procedures
Removal
Before removing the driver's seat assembly, pull the front seat height adjustment switch (A) up to the maximum stop.
Disconnect the negative (-) battery terminal.
Remove the front driver's seat assembly.
(Refer to Body - "Front Seat Assembly")
Disconnect the connectors of the Integrated Memory Seat (IMS) module (A).
Remove the Integrated Memory Seat (IMS) module (A) after loosening the mounting screws.
Installation
Install the power seat memory module (IMS).
Connect the connectors to the power seat memory unit.
Install the driver's front seat assembly.
Connect the negative (-) battery terminal.
Perform the seat end-of-travel position setting using the KDS.
Test yourself
A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.