Kia Stinger CK Quiz
Body Electrical System

Multifunction switch

In this manual: Body Electrical System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
14steps
~84min
3/5difficulty
Done 0 of 14

Specifications

Specifications

Items Specifications
Rated Voltage 12 V DC
Operating Temperature Range -22 - 176°F (-30 - 80°C)
Rated Load Wiper Wiper: 6A (motor load)

Components and Component Location

Components

1. Steering column shaft
2. Light switch
3. Wiper/washer switch
4. Screws		 5. Clock spring
6. Clock spring connectors
7. Steering wheel angle sensor connector
8. Multifunction connector

[Left-hand drive]

[Right-hand drive]

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the steering wheel.

    (Refer to Steering System - "Steering Wheel")

  3. Remove the upper and lower steering column covers after loosening the screws.

    (Refer to Body - "Steering Column Shroud Panel")

  4. Remove the clockspring.

    (Refer to "Restraint System - Driver Airbag Module (DAB) and Clock Spring")

  5. Disconnect the multifunction switch connector (A).

  6. Remove the multifunction switch assembly (A) after loosening the screws.

Installation

  1. Install the multifunction switch.

  2. Install the clock spring.

  3. Install the upper and lower steering column covers.

  4. Install the steering wheel.

  5. Connect the negative (-) battery terminal.

Inspection

Multifunction Switch Inspection

  1. Check the circuit continuity between the terminals in each switch position, as shown below.

    [Left Hand Drive]

    Switch Switch Position Switch Terminal Resistance (Ω, ±3.5%)
    Front Wiper Switch FOG 1-9 330
    OFF ∞
    Intermittent (AUTO) 800
    LOW 1800
    HIGH 5700
    Intermittent Wiper Volume Level 1 7-9 330
    Level 2 690
    Level 3 1310
    Level 4 2610
    Level 5 7310
    Fog Light Switch OFF 9-10 ∞
    ON 910
    Turn Signal Switch OFF 9-12 ∞
    Left 910
    Right 2910
    Dimmer and Headlight Switch OFF 9-13 ∞
    Passing 910
    Dimmer 2910
    Switch OFF 9-14 680
    AUTO / DRL ∞
    Rear Lamp 1680
    Low Beam 5580

    [Right Hand Drive]

    Switch Switch Position Switch Terminal Resistance (Ω, ±3.5%)
    Front Wiper Switch FOG 3-16 330
    OFF ∞
    Intermittent (AUTO) 800
    LOW 1800
    HIGH 5700
    Intermittent Wiper Volume Level 1 2-16 330
    Level 2 690
    Level 3 1310
    Level 4 2610
    Level 5 7310
    Fog Light Switch OFF 14-16 ∞
    Front Fog Lamp 910
    Turn Signal Switch OFF 13-16 ∞
    Left 910
    Right 2910
    Dimmer and Headlight Switch OFF 12-16 ∞
    Passing 910
    Dimmer 2910
    Switch OFF 11-16 680
    AUTO / DRL ∞
    Rear Lamp 1680
    Low Beam 5580

Inspection (with KDS)

  1. In the body electrical system, faults can be quickly diagnosed using the Korean Diagnostic System (KDS).

    The Diagnostic System (KDS) provides the following information.

    1. Self-Diagnosis: Checks malfunction and Diagnostic Trouble Code (DTC)

    2. Current Data: Check the system input/output status.

    3. Actuation Test: Check the system operating status

    4. Additional function: Control of other functions, including the setting parameter system and zero point adjustment.

  2. Select "Vehicle Model" and "Integrated Body Control Unit (IBU)" to be checked in order to inspect the vehicle with the tester.

  3. Select the "Current Data" menu to view the current input/output data status.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.