Kia Stinger CK Quiz
Body Electrical System

Integrated Memory Seat (IMS) Switch

In this manual: Body Electrical System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
10steps
~60min
3/5difficulty
Done 0 of 10

Components and Component Location

Components

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the front driver door trim panel.

    (Refer to Body - "Front Door Trim Panel")

  3. Disconnect the integrated memory seat switch connector (A).

  4. Remove the integrated memory seat switch (A) after loosening the mounting screws.

Installation

  1. Install the integrated memory seat switch.

  2. Connect the integrated memory seat switch connector.

  3. Install the driver's front door trim panel.

  4. Connect the negative (-) battery terminal.

Inspection

  1. Disconnect the integrated memory seat switch connector.

  2. While pressing each switch, check the current flow between the integrated memory seat switch connector and ground. If the electrical values do not meet specification, replace the switch.

    Switch Connector Terminal Resistance
    SET 3-5 680 Ω
    Memory 1 1.5 kΩ
    Memory 2 3.3 kΩ

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.