Kia Stinger CK Quiz
Body Electrical System

Power door mirror actuator

In this manual: Body Electrical System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
13steps
~78min
3/5difficulty
Done 0 of 13

Components and Component Location

Components

1. Side repeater
2. BCW indicator		 3. AVM camera
4. Puddle lamp

Repair Procedures

Inspection

  1. Disconnect the negative (-) battery terminal.

  2. Remove the outside mirror assembly.

  3. Disconnect the power outside rear view mirror connector (A) from the wiring harness.

  4. Apply battery voltage to each terminal as shown in the table and check that the mirror operates normally.

    [Mirror Control (Left/Right)]

    [BCW Indicator]

    [Mirror Heater]

    [Side Repeater Lamp]

    [Puddle Lamp]

    [Folding Mirror]

Diagnosis using KDS

  1. In the body electrical system, faults can be quickly diagnosed using the Korean Diagnostic System (KDS).

    1. Self-Diagnosis: Checks malfunction and Diagnostic Trouble Code (DTC)

    2. Current Data: Check the system input/output status.

    3. Actuation Test: Check the system operating status

    4. Additional function: Control of other functions, including the setting parameter system and zero point adjustment.

  2. Select the "Vehicle Model" and the system to be checked in order to inspect the vehicle with the scan tool.

  3. Select "Driver Seat or Assist Door Module (DDM/ADM)" to check the driver seat or assist door module (DDM/ADM).

  4. Select the "Current Data" menu to view the current input/output data status.

    Input/output data for the sensors related to the driver seat or assist door module (DDM/ADM) can be checked.

  5. If you want to forcibly check the operation of the power door lock, select "Active Test".

Removal

  1. Insert a flat-blade screwdriver or a pry tool as shown in the illustration below, and remove the mirror (A) by applying a short force.

  2. Disconnect the mirror heater connector (A) and the rear corner radar indicator connector (B).

  3. Remove the mirror actuator (A) using a flat-blade screwdriver or pry tool after loosening the screw.

  4. Disconnect the mirror actuator connector (A).

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.