Sunroof Motor

Repair Procedures

Replacement

1. 1

   Disconnect the negative (-) battery terminal.

2. 2

   Remove the roof trim assembly.

   (Refer to Body - "Roof Trim Assembly")

3. 3

   Remove the power window motor (A) after loosening the screws and disconnecting the connector.

   [Glass Motor]

   

4. 4

   Remove the roller blind motor (A) after loosening the screws and disconnecting the connector.

   [Roller Blind Motor]

   

Adjustment

1. 1

   Turn the ignition switch to the ON position or start the engine.

2. 2

   Fully close the sunroof and the sunshade if they are open.

3. 3

   Release the sunroof switch.

4. 4

   Push the sunroof switch forward in the close direction (about 10 seconds) until the glass panel and sunshade move slightly. (You may hear 2 clicks at this time.)

   Then release the sunroof switch.

5. 5

   Within 5 seconds after releasing the sunroof switch, push the sunroof switch forward in the close direction until the sunroof operates as follows again:

   Roller blind open → Glass open → Glass closed → Roller blind closed

6. 6

   Release the sunroof switch after all operations are complete. (Sunroof system has been initialized.)

7. 7

   Check that the sunroof operates with one-touch function.

Inspection

[Glass Motor / Blind Motor Inspection]

1. 1

   Disconnect the negative (-) battery terminal.

2. 2

   Remove the roof trim assembly.

   (Refer to Body - "Roof Trim Assembly")

3. 3

   Disconnect the sunroof wiring connector.

   

4. 4

   Ground the terminals as shown in the table below and check that the sunroof unit operates.