Body Exterior, Doors, Roof & Vehicle Security
B2423 Abd Mtr Time Out
In this manual: Body Exterior, Doors, Roof & Vehicle Security
7steps
~42min
2/5difficulty
Done 0 of 7
DTC DETECTION LOGIC
| DTC No. | CONSULT screen items (Trouble diagnosis content) | DTC detecting condition | |
|---|---|---|---|
| B2423 | ABD MTR TIME OUT (Automatic back door motor time out) |
Diagnosis condition | When the automatic back door is operated approximately 5-6 times (open & close cycles) continuously (for 60–100 seconds in any direction) without any stoppages, the control module will momentarily inhibit operation to protect the system. |
| Signal (terminal) | – | ||
| Threshold | – | ||
| Diagnosis delay time | – | ||
POSSIBLE CAUSE
Normal operation
Automatic back door control module
FAIL-SAFE
Inhibit automatic back door system all function
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Operate automatic back door.
Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Inspection End.
ERASE DTC
CONSULT
At least 180 seconds are passed after automatic back door operation is inhibited.
Ignition switch ON.
Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.
Erase DTC, and then repeat “DTC CONFIRMATION PROCEDURE”. Refer to DTC Confirmation Procedure.
Is DTC detected?
YES>>Replace automatic back door control module. Refer to Removal and Installation.
NO>>Inspection End.
Was this page helpful?