Body Exterior, Doors, Roof & Vehicle Security

Back Door Closure Motor

6steps
~36min
2/5difficulty
Done 0 of 6
Diagnosis Procedure

CHECK BACK DOOR CLOSURE MOTOR INPUT SIGNAL

  1. Ignition switch OFF.

  2. Disconnect back door lock assembly connector.

  3. Check voltage between back door lock assembly harness connector and ground.

    (+)(–)Condition

    Voltage

    (Approx.)
    Back door lock assembly
    ConnectorTerminal
    D557 1 Ground Back door Open operation Battery voltage
    Other than above 0 V
    2 Close operation Battery voltage
    Other than above 0 V

Is the inspection result normal?

YES>>

Replace back door lock assembly. Refer to Removal and Installation.

NO>>

GO TO 2.

CHECK BACK DOOR CLOSURE MOTOR CIRCUIT

  1. Disconnect automatic back door control module connector.

  2. Check continuity between automatic back door control module harness connector and back door lock assembly harness connector.

    Automatic back door control moduleBack door lock assemblyContinuity
    ConnectorTerminalConnectorTerminal
    B56 31 D557 1 Yes
    38 2
  3. Check continuity between automatic back door control module harness connector and ground.

    Automatic back door control module Ground Continuity
    Connector Terminal
    B56 31 No
    38

Is the inspection result normal?

YES>>

Replace automatic back door control module. Refer to Removal and Installation.

NO>>

Repair or replace harness.