Body Exterior, Doors, Roof & Vehicle Security

Intelligent Key Warning Buzzer

8steps
~48min
2/5difficulty
Done 0 of 8
Component Function Check

CHECK FUNCTION

CONSULT

  1. Select “OUTSIDE BUZZER” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.

  2. Select “On” or “Off” to check that it works normally.

Is the inspection result normal?

YES>>

Intelligent Key warning buzzer is OK.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK INTELLIGENT KEY WARNING BUZZER CIRCUIT

  1. Disconnect BCM connector and Intelligent Key warning buzzer connector.

  2. Check continuity between BCM harness connector and Intelligent Key warning buzzer harness connector.

    BCMIntelligent Key warning buzzerContinuity
    ConnectorTerminalConnectorTerminal
    M19 64 E1 3 Yes
  3. Check continuity between BCM harness connector and ground.

    BCM Ground Continuity
    Connector Terminal
    M19 64 No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness.

CHECK INTELLIGENT KEY WARNING BUZZER

Refer to Component Inspection.

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Replace Intelligent Key warning buzzer. Refer to Removal and Installation.

Component Inspection

CHECK INTELLIGENT KEY WARNING BUZZER

  1. Ignition switch OFF.

  2. Disconnect Intelligent Key warning buzzer connector.

  3. Connect battery power supply directly to Intelligent Key warning buzzer terminals and check the operation.

    Intelligent Key warning buzzerOperation
    Terminal
    (+)(−)
    1 3 Buzzer sounds

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace Intelligent Key warning buzzer. Refer to Removal and Installation.