Body Exterior, Doors, Roof & Vehicle Security

Spindle Motor. Rh

6steps
~36min
2/5difficulty
Done 0 of 6
Diagnosis Procedure

CHECK SPINDLE MOTOR INPUT SIGNAL

  1. Ignition switch OFF.

  2. Disconnect spindle unit RH connector.

  3. Check voltage between spindle unit RH harness connector and ground.

    (+)(–)Condition

    Voltage

    (Approx.)
    Spindle unit RH
    ConnectorTerminal
    B162 1 Ground Back door Auto close operation Battery voltage
    2 Auto open operation

Is the inspection result normal?

YES>>

Replace spindle unit RH. Refer to Removal and Installation.

NO>>

GO TO 2.

CHECK SPINDLE MOTOR CIRCUIT

  1. Disconnect automatic back door control module connector.

  2. Check continuity between automatic back door control module harness connector and spindle unit harness connector.

    Automatic back door control moduleSpindle unit RHContinuity
    ConnectorTerminalConnectorTerminal
    B56 36 B162 1 Yes
    29 2
  3. Check continuity between automatic back door control module harness connector and ground.

    Automatic back door control module Ground Continuity
    Connector Terminal
    B56 36 No
    29

Is the inspection result normal?

YES>>

Replace automatic back door control module. Refer to Removal and Installation.

NO>>

Repair or replace harness.