Body Exterior, Doors, Roof & Vehicle Security
B261b Res Eng Run Stuck Malfunc
In this manual: Body Exterior, Doors, Roof & Vehicle Security
6steps
~36min
2/5difficulty
Done 0 of 6
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B261B | RES ENG RUN STUCK MALFUNC (Remote engine starter engine run stuck malfunction) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | The BCM has requested ignition OFF but ECM keeps the engine running for more than 10 seconds after the OFF request was made | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
ECM
BCM
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Select "Self Diagnostic Result" mode of "BCM".
Check BCM for DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Inspection End.
CHECK ECM IGNITION, POWER AND GROUND CIRCUITS
Check ECM ignition power and ground circuits. Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace ECM. Refer to Removal and Installation. GO TO 2.
NO>>Repair or replace harness or connectors.
INSPECTION
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of "BCM".
Select “ERASE”.
Perform Nissan Murano vehicle remote start operation.
Does DTC B261B return?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Inspection End.
Was this page helpful?