U1320 Reprogramming
DTC DETECTION LOGIC
| DTC No. | CONSULT screen items (Trouble diagnosis content) | DTC detecting condition | |
|---|---|---|---|
| U1320–06 | REPROGRAMMING (Automatic back door reprogramming) |
Diagnosis condition | All times |
| Signal (terminal) | – | ||
| Threshold | When the automatic back door control module configuration is not successful | ||
| Diagnosis delay time | – | ||
| U1320–42 | REPROGRAMMING (Automatic back door reprogramming) |
Diagnosis condition | All times |
| Signal (terminal) | – | ||
| Threshold | When the automatic back door control module configuration is not successful | ||
| Diagnosis delay time | – | ||
| U1320–51 | REPROGRAMMING (Automatic back door reprogramming) |
Diagnosis condition | All times |
| Signal (terminal) | – | ||
| Threshold | When the automatic back door control module configuration is not successful | ||
| Diagnosis delay time | – | ||
POSSIBLE CAUSE
Improper installation of back door assembly
[CALIBRATION OF AUTOMATIC BACK DOOR POSITION INFORMATION]: not complete
Back door mechanism
Automatic back door control module
Harness or connectors
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Operate automatic back door.
Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Inspection End.
CALIBRATION OF AUTOMATIC BACK DOOR POSITION INFORMATION
CONSULT
Perform initialization setting of automatic back door position information.
Refer to Work Procedure.
Erase DTC, and then repeat “DTC CONFIRMATION PROCEDURE”.
Is DTC detected?
YES>>GO TO 2.
NO>>Inspection End.
CHECK INSTALLATION OF BACK DOOR ASSEMBLY
Check that back door assembly is installed normally.
Refer to Adjustment.
Check back door assembly mechanism for deformation, looseness, rattle, interference with other parts, and pinched foreign materials.
Is the inspection result normal?
YES>>Replace automatic back door control module. Refer to Removal and Installation.
NO>>Repair or replace the malfunctioning parts.