Body Exterior, Doors, Roof & Vehicle Security

B242f Abd Buzzer

16steps
~96min
4/5difficulty
Done 0 of 16
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC detecting condition
B242F–12

ABD BUZZER

(Automatic back door warning buzzer)
Diagnosis condition All times
Signal (terminal) Automatic back door warning buzzer signal (automatic back door control module connector terminal: 2)
Threshold Automatic back door control module detects a malfunction of automatic back door warning buzzer circuit
Diagnosis delay time –

POSSIBLE CAUSE

  • Harness or connectors (automatic back door warning buzzer circuit is open or shorted)

  • Automatic back door control module

FAIL-SAFE

–

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Operate automatic back door.

  3. Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK AUTOMATIC BACK DOOR WARNING BUZZER OUTPUT SIGNAL CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect automatic back door control module and automatic back door warning buzzer connector.

  3. Check continuity between automatic back door control module harness connector and automatic back door warning buzzer harness connector.

    Automatic back door control moduleAutomatic back door warning buzzerContinuity
    ConnectorTerminalConnectorTerminal
    B55 2 B93 3 Yes
  4. Check continuity between automatic back door control module harness connector and ground.

    Automatic back door control module Ground Continuity
    Connector Terminal
    B55 2 No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness.

ERASE DTC

CONSULT

  1. Connect automatic back door control module and automatic back door warning buzzer connector.

  2. Ignition switch ON.

  3. Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.

  4. Erase DTC, and then repeat “DTC CONFIRMATION PROCEDURE”. Refer to DTC Confirmation Procedure.

Is DTC “B242F-12” detected?

YES>>

GO TO 3.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

REPLACE AUTOMATIC BACK DOOR WARNING BUZZER AND ERASE DTC

CONSULT

  1. Ignition switch OFF.

  2. Replace automatic back door warning buzzer.

  3. Ignition switch ON.

  4. Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.

  5. Erase DTC, and then repeat “DTC CONFIRMATION PROCEDURE”. Refer to DTC Confirmation Procedure.

Is DTC “B242F-12” detected?

YES>>

Replace automatic back door control module. Refer to Removal and Installation.

NO>>

Inspection End.