Body Exterior, Doors, Roof & Vehicle Security

Back Door Request Switch

11steps
~66min
3/5difficulty
Done 0 of 11
Component Function Check

CHECK FUNCTION

CONSULT

  1. Select “REQ SW-BD/TR” in “Data Monitor” mode of “BCM(INTELLIGENT KEY)”.

  2. Check that the function operates normally according to the following conditions:

Monitor ItemConditionStatus
REQ SW-BD/TR Back door request switch Pressed On
Released Off

Is the inspection result normal?

YES>>

Back door request switch is OK.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK BACK DOOR REQUEST SWITCH INPUT SIGNAL

  1. Ignition switch OFF.

  2. Disconnect back door opener switch connector.

  3. Check voltage between back door opener switch harness connector and ground.

    (+)(–)

    Voltage

    (Approx.)
    Back door opener switch
    ConnectorTerminal
    D559 4 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK BACK DOOR REQUEST SWITCH CIRCUIT

  1. Disconnect BCM connector.

  2. Check continuity between BCM harness connector and back door opener switch harness connector.

    BCMBack door opener switchContinuity
    ConnectorTerminalConnectorTerminal
    M20 83 D559 4 Yes
  3. Check continuity between BCM harness connector and ground.

    BCM Ground Continuity
    Connector Terminal
    M20 83 No

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness.

CHECK BACK DOOR REQUEST SWITCH GROUND CIRCUIT

Check continuity between back door opener switch harness connector and ground.

Back door opener switch Ground Continuity
Connector Terminal
D559 3 Yes

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace harness.

CHECK BACK DOOR REQUEST SWITCH

Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Replace back door opener switch. Refer to Removal and Installation.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.

Component Inspection

CHECK BACK DOOR REQUEST SWITCH

  1. Ignition switch OFF.

  2. Disconnect back door opener switch connector.

  3. Check continuity between back door opener switch terminals.

    Back door opener switchConditionContinuity
    Terminal
    3 4 Back door request switch Pressed Yes
    Released No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace back door opener switch. Refer to Removal and Installation.