Body Exterior, Doors, Roof & Vehicle Security

Integrated Homelink Transceiver

5steps
~30min
2/5difficulty
Done 0 of 5
Component Function Check

CHECK FUNCTION

Check that system receiver (garage door opener, etc.) operates with original hand-held transmitter.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Receiver or hand-held transmitter is malfunctioning.

CHECK ILLUMINATION

  1. Ignition switch OFF.

  2. Does red light of transceiver illuminate when any transceiver button is pressed?

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Refer to Diagnosis Procedure.

CHECK TRANSMITTER

Check transceiver with Tool*.

*:For details, refer to Technical Service Bulletin.

Is the inspection result normal?

YES>>

Receiver or hand-held transmitter malfunction, not Nissan Murano vehicle related.

NO>>

Replace auto anti-dazzling inside mirror (HomeLink® universal transceiver). Refer to Removal and Installation.

Diagnosis Procedure

CHECK POWER SUPPLY

  1. Ignition switch OFF.

  2. Disconnect auto anti-dazzling inside mirror (HomeLink® universal transceiver) connector.

  3. Check voltage between auto anti-dazzling inside mirror (HomeLink® universal transceiver) harness connector and ground.

Auto anti-dazzling inside mirror

(HomeLink® universal transceiver)
–Condition

Voltage

(Approx.)
ConnectorTerminal
R7 10 Ground Ignition switch position: OFF Battery voltage
Ignition switch position: ON
6 Ignition switch position: OFF 0
Ignition switch position: ON Battery voltage

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Check the following items:

  • 10A fuse No. 29 located in the fuse block (J/B).

  • 10A fuse No. 9 located in the fuse block (J/B).

  • Harness for open or short between fuse and auto anti-dazzling inside mirror (HomeLink® universal transceiver).

CHECK GROUND CIRCUIT

Check continuity between auto anti-dazzling inside mirror (HomeLink® universal transceiver) harness connector and ground.

Auto anti-dazzling inside mirror

(HomeLink® universal transceiver)
Ground Continuity
Connector Terminal
R7 8 Yes

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair harness.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.