Body Exterior, Doors, Roof & Vehicle Security

B26fe Hood Sw Can Diag Error

11steps
~66min
3/5difficulty
Done 0 of 11
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC Detection Condition
B26FE

HOOD SW CAN DIAG ERROR

(Hood switch CAN communication diagnostic error)
Diagnosis condition When ignition switch is ON.
Signal (terminal) IPDM E/R terminals 94,96
Threshold BCM detects that the hood switch input is malfunctioning
Diagnosis delay time 3 seconds

POSSIBLE CAUSE

  • Hood switch

  • Harness or connector

    [hood switch circuit is open or shorted]

  • IPDM E/R

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Hood switch is OK.

Diagnosis Procedure

CHECK HOOD SWITCH SIGNAL CIRCUITS

  1. Ignition switch OFF.

  2. Disconnect hood switch connector.

  3. Check voltage between hood switch harness connector and ground.

(+)(–)

Voltage

(Approx.)
Hood switch
ConnectorTerminal
E205 1 Ground Battery voltage
2

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK HOOD SWITCH SIGNAL CIRCUITS

  1. Disconnect IPDM E/R connector.

  2. Check continuity between IPDM E/R harness connector and hood switch harness connector.

    IPDM E/RHood switchContinuity
    ConnectorTerminalConnectorTerminal
    E218 94 E205 1 Yes
    96 2
  3. Check continuity between IPDM E/R harness connector and ground.

    IPDM E/R Ground Continuity
    Connector Terminal
    E218 94 No
    96

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair or replace harness.

CHECK HOOD SWITCH GROUND CIRCUIT

Check continuity between hood switch harness connector and ground.

Hood switch Ground Continuity
Connector Terminal
E205 3 Yes

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace harness.

CHECK HOOD SWITCH

Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Replace hood switch. Refer to Removal and Installation.

CHECK BCM CONFIGURATION

Refer to Configuration List.

>>

Inspection End.

Component Inspection

CHECK HOOD SWITCH

  1. Ignition switch OFF.

  2. Disconnect hood switch connector.

  3. Check continuity between hood switch terminals.

    Hood switchConditionContinuity
    Terminal
    1 3 Hood switch Press Yes
    Release No
    2 Press No
    Release Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace hood switch. Refer to Removal and Installation.