Body Exterior, Doors, Roof & Vehicle Security

Remote Keyless Entry Receiver

7steps
~42min
2/5difficulty
Done 0 of 7
Component Function Check

CHECK FUNCTION

CONSULT

  1. Select “RKE OPE COUN1” in “Data Monitor” mode of “BCM(INTELLIGENT KEY)”.

  2. Check that the function operates normally according to the following conditions:

Monitor ItemCondition
RKE OPE COUN1 Checks whether value changes when operating Intelligent Key.

Is the inspection result normal?

YES>>

Remote keyless entry receiver is OK.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK REMOTE KEYLESS ENTRY RECEIVER OUTPUT SIGNAL

  1. Ignition switch OFF.

  2. Check signal between BCM harness connector and ground using oscilloscope.

    (+)(–)Condition

    Signal

    (Reference value)
    BCM
    ConnectorTerminal
    M80 119 Ground Standby state
    Press the Intelligent Key lock or unlock button.

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

GO TO 2.

CHECK REMOTE KEYLESS ENTRY RECEIVER CIRCUIT

  1. Disconnect BCM and remote keyless entry receiver connectors.

  2. Check continuity between BCM harness connector and remote keyless entry receiver harness connector.

    BCMRemote keyless entry receiverContinuity
    ConnectorTerminalConnectorTerminal
    M80 119 M86 2 Yes
  3. Check continuity between BCM harness connector and ground.

    (+)(–)Continuity
    BCM
    ConnectorTerminal
    M80 119 Ground No

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness.

CHECK REMOTE KEYLESS ENTRY RECEIVER POWER SUPPLY

Check voltage between remote keyless entry receiver harness connector and ground.

(+)(–)

Voltage

(Approx.)
Remote keyless entry receiver
ConnectorTerminal
M86 1 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Check 10A fuse No. 25 [located in fuse block (J/B)].

NO>>

Repair or replace harness between remote keyless entry receiver and 10A fuse No. 25.

CHECK REMOTE KEYLESS ENTRY RECEIVER GROUND CIRCUIT

Check continuity between remote keyless entry receiver harness connector and ground.

Remote keyless entry receiver Ground Continuity
Connector Terminal
M86 3 Yes

Is the inspection result normal?

YES>>

Replace remote keyless entry receiver. Refer to Removal and Installation.

NO>>

Repair or replace harness.