Theft Deterrent / Keyless Entry

The interior entry buzzer does not sound

~2min read

DESCRIPTION

The smart key system (for the entry function) uses the buzzer in the combination meter assembly to provide various warnings inside the cabin. When the conditions for each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer activation request signal to the combination meter assembly via the CAN communication system, and the buzzer sounds.

PRECAUTION / NOTICE / HINT

NOTICE:

  • The Smart Key System (for Access Function) uses a LIN communication system and a CAN communication system. Check the communication function by following the procedure described in HOW TO USE TROUBLESHOOTING MODE. Troubleshoot the Smart Key System (for Access Function) after confirming that the communication systems operate normally.

    Click here

  • While using the Techstream with the vehicle engine switch OFF, connect the Techstream to the DLC3 and turn a welcome light switch ON and OFF at intervals of no more than 1.5 seconds until communication between the Techstream and the vehicle starts. Then select the vehicle type in manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, regularly switch a welcome light switch between ON and OFF at intervals of no more than 1.5 seconds to maintain communication between the Techstream and the vehicle.

    Click here

  • After repair, confirm that no DTCs are output.

PROCEDURE

  1. CHECK UNLOCK DOOR OPERATION

(a) Check whether the function operates normally.

Click here

Result:

Result

Proceed to

The unlock function operates normally

A

The unlock function does not operate normally

B

A

GO TO METER/GAUGE SYSTEM

B

GO TO THE OTHER PROBLEM