Replacing the clutch cable

Remove the battery and battery bracket, see page 14.

Using a ruler on the release lever, measure the length of the protruding thread up to the locknut. This allows the new clutch cable to be preset to the measured length.

Unscrew the locknut and nut, unhook the cable from the release lever and the abutment on the transmission.

Lift the floor covering - 1 - in the driver's footwell. Unhook the cable eyelet - 3 - from the clutch pedal - 2 -.

Release the cable from the guides - 1 - in the engine compartment. Figure - a - shows the brackets on models without air conditioning, - b - with air conditioning.

Pull the cable sheath - 2 - out of the bulkhead from the engine compartment side, below the brake booster, together with the grommet - 1 -.

Press the cable sheath into the bulkhead. Do not forget the grommet between the cable and the bulkhead.

Hook the cable into the clutch pedal. Fold back the floor covering.

Route the cable in the brackets and hook it onto the transmission release lever.

Screw the adjusting nut onto the release lever to the previously measured value.

Adjust the clutch.

Install the battery and battery bracket, see page 14.