Hyundai Elantra CN7 Quiz

Automatic Transmission - Removal and Installation (For A4AF3)

In this manual: Automatic Transmission - Removal and Installation (For A4AF3)
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~2min read
1special tools

1. Remove the drain plug and drain the ATF from the transmission.

2. Снимите корпус воздушного фильтра в сборе.

2. Remove the air cleaner housing assembly.

3. Снимите хомуты и отсоедините отводящий и подводящий шланги маслоохладителя

3. Remove the clamps and disconnect the outlet and inlet A/T oil cooler hoses.

After disconnecting the hoses, plug the hose ends and the transaxle fittings to prevent dust or foreign material from entering.

4. Disconnect the A/T control cable.

5. Снимите трос привода спидометра.

5. Disconnect the speedometer cable.

6. Отсоедините разъем выключателя блокировки стартера (переключателя селектора

6. Disconnect the inhibitor switch (A/T selector switch) connector, the solenoid valve connector, the ATF temperature sensor connector, and the kickdown servo switch connector.

7. Отверните болт крепления коробки передач к двигателю, расположенный на верхней

7. Remove the transaxle-to-engine mounting bolt located on the upper part of the transaxle.

8. Закрепите двигатель на специальном приспособлении (траверса 09200-38001) за

8. Secure the engine to the special tool (engine support fixture 09200-38001) using the mounting brackets.

9. Raise the vehicle on a hoist.

10. Disconnect the tie rod ends and the lower arm ball joints, and remove the drive shafts. Remove the steering gear and the stabilizer bar.

11. Disconnect the universal joint of the steering shaft.

Before disconnecting, make alignment marks on the steering shaft universal joint and the steering gear shaft to simplify reassembly.

12. Remove the mounting bolts of the subframe and remove the subframe.

13. Снимите стартер.

13. Remove the starter motor.

14. Remove the transaxle mounting bolts.

15. Remove the transaxle-to-engine mounting bolts.

16. Снимите коробку передач в сборе с помощью трансмиссионной телескопической

16. Remove the transaxle assembly using a T/M jack.

1. The engine and transaxle mounts must be installed in a specific order.

2. Mount bracket installation order:

1) Engine side mount bracket

2) Transaxle mount bracket

3) Engine rear mount bracket

4) Engine front mount bracket

3. Be careful when installing the engine front mount bracket. Do not damage or deform the mount. If the mount is damaged, severe engine vibration may occur at idle.

INSTALLATION

1. Подсоедините гидротрансформатор со стороны коробки передач и установите коробку

1. Connect the torque converter on the transaxle side, then install the transaxle assembly to the engine.

If the torque converter is installed to the engine first, the transaxle oil seal will be damaged when installing the transaxle. Therefore, always install the torque converter from the transaxle side before assembling the powertrain.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.