Hyundai Elantra CN7 Quiz

Automatic transmission hydraulic control pressure test

In this manual: Automatic transmission hydraulic control pressure test
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read

1. Warm up the engine and transmission until the ATF temperature reaches normal operating temperature (80 - 100°C).

2. Raise the vehicle on a lift so that the drive wheels are off the ground.

3. Connect the special tools (adapter and pressure gauge) to the corresponding pressure test ports.

4. Measure the ATF pressure in each circuit under the conditions shown in the "AUTOMATIC TRANSMISSION HYDRAULIC CONTROL PRESSURE TEST" table, and check that the measured values are within the standard values.

5. Если измеренное давление выходит за пределы номинальных значений, то устраните

5. If the measured pressure is outside the standard values, repair the fault in accordance with the "Troubleshooting by Automatic Transmission Hydraulic Control Pressure" table.


AUTOMATIC TRANSMISSION HYDRAULIC CONTROL PRESSURE TEST

AUTOMATIC TRANSMISSION HYDRAULIC CONTROL PRESSURE TROUBLESHOOTING TABLE

Функция самодиагностики

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.