Hyundai Elantra CN7 Quiz

Automatic transmission hydraulic control pressure test

In this manual: Automatic transmission hydraulic control pressure test
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
2special tools

1. Warm up the transaxle to normal operating temperature (ATF).

2. Raise the vehicle on a lift so that the front wheels are off the ground.

3. Install a diagnostic tachometer to measure engine crankshaft speed so that its reading can be easily read.

4. Подсоедините переходник (09452-21002) и манометр (09452-21500) к соответствующим

4. Connect the adapter (09452-21002) and the pressure gauge (09452-21500) to the corresponding pressure test ports.

When checking the reverse pressure, use a 3000 kPa pressure gauge.

5. Измерьте давление масла в АКПП (ATF) в каждой магистрали при различных условиях.

5. Measure the ATF pressure in each line under various conditions. Check that the measured values are within the specified ranges given in the table "Transaxle Hydraulic Control System Specified Pressures" below. If the measured pressure is outside the specified range, perform the inspection and repair the fault in accordance with the table "Preliminary Troubleshooting for Incorrect Pressure" on the next page.


TRANSAXLE HYDRAULIC CONTROL SYSTEM SPECIFIED PRESSURES

SW-ON: Set the overdrive switch to the "ON" position.

SW-OFF: Set the overdrive switch to the "OFF" position.

: Hydraulic pressure is built up in the transaxle control system, but there is no steady specified value.

PRELIMINARY TROUBLESHOOTING FOR INCORRECT PRESSURE


PRELIMINARY TROUBLESHOOTING FOR INCORRECT PRESSURE

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.