Theft Deterrent / Keyless Entry

No Communication in Immobiliser System (B2796)

~3min read

DESCRIPTION

This DTC is stored when a key is inserted into the key cylinder but no communication is established between the key and the transponder key ECU assembly.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Note

B2796

No communication in immobiliser system.

The key ID code cannot be transmitted to the transponder key ECU assembly (1 trip detection logic*).

  • Key
  • Wire harness or connector
  • Transponder Key Coil
  • Transponder Key ECU Assembly
  • Insert the key into the key cylinder.
  • *: Output only when a malfunction is detected.
Vehicle condition and fail-safe function when a malfunction is detected

Vehicle Condition When Malfunction Is Detected

Fail-safe function when a malfunction is detected

The engine does not start.

-

Related Data List and Active Test

DTC No.

Data List and Active Test

B2796

-

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • If the transponder key ECU assembly or key is replaced, refer to the Registration section.

    Click here

  • After repair, make sure no DTCs are output by performing the "DTC Output Confirmation Operation" procedure.

PROCEDURE

  1. CLEAR DTCs

(a) Clear the DTCs.

Body Electrical > Immobiliser > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Insert and remove each registered key one at a time, and check whether DTCs are output each time.

Body Electrical > Immobiliser > Trouble Codes

HINT:

Before checking the DTCs, perform the "DTC Output Confirmation Operation" procedure.

OK:

DTC B2796 is not output.

Result:

Result

Proceed to

DTC B2796 is not output

A

DTC B2796 is output for all keys

B

DTC B2796 is output for all keys

C

A

USE SIMULATION METHOD TO CHECK

C

GO TO STEP 6

B
  1. REPLACE TRANSPONDER KEY ECU ASSEMBLY

(a) Replace the transponder key ECU assembly with a new one.

Click here

HINT:

Refer to Registration.

Click here

NOTICE:

Key ID code registration is required when the transponder key ECU assembly is replaced.

Click here

NEXT
  1. CLEAR DTCs

(a) Clear the DTCs.

Body Electrical > Immobiliser > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Check the DTCs.

Body Electrical > Immobiliser > Trouble Codes

HINT:

Before checking the DTCs, perform the "DTC Output Confirmation Operation" procedure.

OK:

DTC B2796 is not output.

Result:

Result

Proceed to

DTC B2796 is not output

A

DTC B2796 is output

B

A

END (TRANSPONDER KEY ECU ASSEMBLY WAS DEFECTIVE)

B

REPLACE THE KEY FOR WHICH THE DTC IS OUTPUT

  1. REPLACE THE KEY

(a) Replace the key for which the DTC was stored.

NOTICE:

Key ID code registration is required when the key is replaced.

Click here

NEXT
  1. CLEAR DTCs

(a) Clear the DTCs.

Body Electrical > Immobiliser > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Check the DTCs.

Body Electrical > Immobiliser > Trouble Codes

HINT:

Before checking the DTCs, perform the "DTC Output Confirmation Operation" procedure.

OK:

DTC B2796 is not output.

Result:

Result

Proceed to

DTC B2796 is not output

A

DTC B2796 is output

B

A

END (KEY WAS DEFECTIVE)

B

REPLACE TRANSPONDER KEY ECU ASSEMBLY