Theft Deterrent / Keyless Entry

Key Code Not Matched (B2795)

~3min read

DESCRIPTION

This DTC is stored when a key with a different vehicle serial number is inserted into the key cylinder.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Note

B2795

Key code not matched

A key with a different vehicle serial number is inserted into the key cylinder (1 trip detection logic*).

  • Key
  • Transponder Key ECU Assembly
  • Insert the key into the key cylinder.
  • *: Output only when a malfunction is detected.
Vehicle condition and fail-safe function when a malfunction is detected

Vehicle Condition When Malfunction Is Detected

Fail-safe function when a malfunction is detected

The engine does not start.

-

Related Data List and Active Test Items

DTC No.

Data List and Active Test

B2795

-

PRECAUTION / NOTICE / HINT

NOTICE:

  • If the transponder key ECU assembly or key is replaced, refer to the Registration section.

    Click here

  • After repair, make sure no DTCs are output by performing the "DTC Output Confirmation Operation" procedure.

PROCEDURE

  1. CLEAR DTCs

(a) Clear the DTCs.

Body Electrical > Immobiliser > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Insert and remove each registered key one at a time, and check whether DTCs are output each time.

Body Electrical > Immobiliser > Trouble Codes

HINT:

  • Before checking the DTCs, perform the "DTC Output Confirmation Operation" procedure.
  • If DTC B2795 is stored, check the DTCs using the next key after clearing the DTCs.

OK:

DTC B2795 is not output.

Result:

Result

Proceed to

DTC B2795 is not output

A

DTC B2795 is output for all keys

B

DTC B2795 is output for all keys

C

A

USE SIMULATION METHOD TO CHECK

B

REPLACE TRANSPONDER KEY ECU ASSEMBLY

C
  1. CHECK OPERATION (IG ON)

(a) Make sure the ignition switch can be turned ON using the key for which the DTC was stored.

OK:

The ignition switch can be turned ON using the key (for which the DTC was stored).

NG

REPLACE THE KEY FOR WHICH THE DTC IS OUTPUT

OK
  1. REGISTRATION

(a) Clear the DTCs.

Click here

Body Electrical > Immobiliser > Clear DTCs

(b) Re-register the key ID code in the transponder key ECU assembly.

OK:

The registration procedure can be completed successfully.

OK

END (KEY REGISTRATION FAILED)

NG

REPLACE THE KEY FOR WHICH THE DTC IS OUTPUT