Theft Deterrent / Keyless Entry

Immobiliser System Presence Detection (B279C)

~1min read

DESCRIPTION

If an ECM incompatible with the immobiliser system is installed, the ECM stores this DTC.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Note

B279C

Immobiliser presence detection

An ECM that is incompatible with the immobiliser system is installed.

ECM

  • Check the DTCs.
Vehicle condition and fail-safe function when a malfunction is detected

Vehicle Condition When Malfunction Is Detected

Fail-safe function when a malfunction is detected

The engine does not start.

-

Related Data List and Active Test

DTC No.

Data List and Active Test

B279C

-

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the ECM, refer to the Registration section.

    Click here

  • After repair, make sure no DTCs are output by performing the "DTC Output Confirmation Operation" procedure.

PROCEDURE

  1. CLEAR DTCs

(a) Clear the DTCs.

Powertrain > Engine and ECT > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Start the engine.

(b) Check DTCs.

Powertrain > Engine and ECT > Trouble Codes

HINT:

Before checking the DTCs, perform the "DTC Output Confirmation Operation" procedure.

OK:

DTC B279C is not output.

Result:

Result

Proceed to

DTC B279C is not output

A

DTC B279C is output

B

A

USE SIMULATION METHOD TO CHECK

B
  1. REPLACE ECM

(a) Replace the current ECM with a correct ECM.

Click here

NEXT

END