Heater / Air Conditioning

How to Use Troubleshooting

~2min read

PRECAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the air conditioning system.
  • *: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CHECK BATTERY VOLTAGE

(a) Check the battery voltage with the ignition switch OFF.

Standard voltage:

11 à 14 V

If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.

NEXT
  1. CHECK CAN COMMUNICATION SYSTEM FUNCTION*

(a) Using the Techstream, check for DTCs related to the CAN communication system.

Click here

Result:

Result

Proceed to

CAN communication system DTCs are not output

A

CAN communication system DTCs are output

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTCs*

(a) Check whether DTCs are output and record them.

Click here

Body Electrical > Air Conditioner > Trouble Codes

(b) Clear the DTCs.

Click here

Body Electrical > Air Conditioner > Clear DTCs

(c) Check the DTCs again. Based on the DTCs output above, try to cause the air conditioning system DTC to be output by simulating the operation indicated by the DTC.

Click here

Body Electrical > Air Conditioner > Trouble Codes

Result:

Result

Proceed to

No DTCs are output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A
  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Refer to the Symptom Troubleshooting Table.

Click here

Result:

Result

Proceed to

The malfunction is not listed in the Problem Symptoms Table

A

The malfunction is listed in the Problem Symptoms Table

B

B

REFER TO SYMPTOM TROUBLESHOOTING TABLE

A
  1. GENERAL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test.

Click here

(b) ECU terminals.

Click here

(c) Check on Vehicle.

(d) Check.

NEXT
  1. ADJUST, REPAIR OR REPLACE

NEXT

END