Audi A3 Quiz
Body Electrical Equipment

Removing and Installing the Speaker

In this manual: Body Electrical Equipment
Owner's Manual — 42Routine Care and Maintenance — 32Engine — 22Engine Cooling System — 9Ventilation, Heating and Air Conditioning Systems — 11Fuel System — 9Fuel Injection System — 4Diesel engine injection system — 5Exhaust System — 9Electronic Ignition and Fuel Injection Control System — 6Charging and Starting Systems — 12Manual transmission — 12Clutch and Drive Shafts — 6Brake System — 13Front Suspension — 5Rear Suspension — 6Steering — 7Body — 70Body Electrical Equipment — 37Wiring Diagrams — 35
~1min read

Low-/Mid-/High-Frequency Speaker

PROCEDURE

1. Remove the door trim panel. Refer to Removal and Installation of Door Trim Panel.

2. Carefully detach the damping mat from the rear of the trim panel –1–.

3. Disconnect the speaker connector.

4. Remove the 3 Torx T20 screws from the low-frequency speaker –2– and remove the speaker from the trim panel.

5. Remove the Torx T20 screw from the mid-/high-frequency speaker –4– and remove the speaker from the trim panel. 3 – telephone speaker.

6. Installation is performed in the reverse order of removal. Full-Range Speaker

PROCEDURE

1. Remove the rear side trim, refer to subsection Removal and Installation of Rear Side Trim.

2. Disconnect connector –1–.

3. Remove the 3 Torx T20 screws from the full-range speaker –2– and remove the speaker from the trim panel.

4. Install in reverse order of removal.

Test yourself

A quick Audi A3 quiz: every answer comes with an explanation and a link to the manual page.