Audi A3 Quiz
Body Electrical Equipment

Front Turn Signal Light Removal and Installation

In this manual: Body Electrical Equipment
Owner's Manual — 42Routine Care and Maintenance — 32Engine — 22Engine Cooling System — 9Ventilation, Heating and Air Conditioning Systems — 11Fuel System — 9Fuel Injection System — 4Diesel engine injection system — 5Exhaust System — 9Electronic Ignition and Fuel Injection Control System — 6Charging and Starting Systems — 12Manual transmission — 12Clutch and Drive Shafts — 6Brake System — 13Front Suspension — 5Rear Suspension — 6Steering — 7Body — 70Body Electrical Equipment — 37Wiring Diagrams — 35
~1min read

GENERAL INFORMATION

The turn signal light is removed with the headlight installed. REMOVAL

PROCEDURE

1. Insert a long Phillips screwdriver through the side opening in the cross member (arrow in illustration).

2. Turn the turn signal adjustment locking screw –1– 1/4 turn.

3. Press the screw with the bar downward and remove the turn signal light –2– forward (in the direction of the arrow) from the body.

4. Disconnect the connector. INSTALLATION

PROCEDURE

1. Mate the connector.

2. Insert the turn signal light bars –1– into the guides –2– of the headlight housing and shift it rearward until the bar clicks into place.

3. Check that the turn signal light is secure by pulling it forward. The bulb must not come out.

4. Turn the screwdriver 1/4 turn to the right to lock it in place.

Test yourself

A quick Audi A3 quiz: every answer comes with an explanation and a link to the manual page.