BMW 1 Quiz
Body Electrical Equipment

Rear Lamp Removal and Installation

In this manual: Body Electrical Equipment
Introduction — 10Owner's Manual — 29Routine Care and Maintenance — 30Engine — 18Cooling and Heating Systems — 13Fuel and Exhaust Systems — 29Engine Electrical Equipment — 20Manual Transmission — 4Automatic Transmission — 4Clutch and Drive Shafts — 12Brake System — 19Suspension and Steering — 22Body — 36Body Electrical Equipment — 34Electrical Circuit Diagrams — 30On-board diagnostic system — 5
~1min read

REMOVAL

1. Remove the bulb holder, refer to the Section Incandescent Bulb Replacement.
2. Unscrew the four mounting nuts and remove the lens outward.

3. Проверьте состояние прокладки. При необходимости замените.

3. Check the condition of the gasket. Replace if necessary.

INSTALLATION

1. Install the lens and secure it with the screws.
2. Install the bulb holder.

Test yourself

A quick BMW 1 quiz: every answer comes with an explanation and a link to the manual page.