BMW 1 Quiz
Body Electrical Equipment

Removal and Installation of Wiper Motor

In this manual: Body Electrical Equipment
Introduction — 10Owner's Manual — 29Routine Care and Maintenance — 30Engine — 18Cooling and Heating Systems — 13Fuel and Exhaust Systems — 29Engine Electrical Equipment — 20Manual Transmission — 4Automatic Transmission — 4Clutch and Drive Shafts — 12Brake System — 19Suspension and Steering — 22Body — 36Body Electrical Equipment — 34Electrical Circuit Diagrams — 30On-board diagnostic system — 5
~1min read
010203040502518N·mlb·ft
Tightening torque found on this page

REMOVAL

1. Remove the wiper drive.
2. Disconnect the crank (4) from the shaft by removing the nut (5).
3. Remove the three mounting bolts (6) of the electric motor and remove it from the bracket.

УСТАНОВКА

INSTALLATION

1. Before installing the motor, set it to the park position. To do this, connect the plug connector and start the motor. Then switch it off with the wiper switch and let it stop at the end position. Disconnect the plug connector.
2. Secure the wiper motor to the bracket.
3. Install the crank so that it is in line with the links. Tighten the nut to the torque of 25 N·m.
4. Install the wiper arm.

Test yourself

A quick BMW 1 quiz: every answer comes with an explanation and a link to the manual page.