Theft Deterrent / Keyless Entry

Immobiliser System Presence Detection (B279C)

~2min read

DESCRIPTION

If an ECM incompatible with the immobiliser system is installed, the ECM stores this DTC.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Note

B279C

Immobiliser presence detection

An ECM incompatible with the immobiliser system is installed. (1 trip detection logic*)

ECM

-

  • *: Detected only when a malfunction is identified.
Vehicle Condition and Fail-Safe Function When Malfunction Is Detected

Vehicle Condition When Malfunction Is Detected

Fail-Safe Function When Malfunction Is Detected

The engine does not start.

-

Related Data List and Active Test

DTC No.

Data List and Active Test

B279C

-

PRECAUTION / NOTICE / HINT

NOTICE:

  • While using the Techstream with the vehicle engine switch OFF, connect the Techstream to the DLC3 and turn a welcome light switch ON and OFF at intervals of no more than 1.5 seconds until communication between the Techstream and the vehicle starts. Then select the vehicle type in manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, regularly switch a welcome light switch between ON and OFF at intervals of no more than 1.5 seconds to maintain communication between the Techstream and the vehicle.
  • Before replacing the ECM, refer to the Registration section.

    Click here

  • After completing the repairs, make sure no DTCs are output by performing the "DTC Output Confirmation Operation" procedure.

PROCEDURE

  1. CLEAR DTCs

(a) Clear the DTCs.

Click here

Powertrain > Engine and ECT > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Check the DTCs.

Click here

Powertrain > Engine and ECT > Trouble Codes

OK:

No B279C is output.

OK

USE SIMULATION METHOD TO CHECK

NG
  1. REPLACE CURRENT ECM WITH CORRECT ECM

(a) Replace the current ECM with a suitable ECM.

Click here

NEXT

END