Diagnostic System
DIAGNOSTIC SYSTEM
DESCRIPTION
(a) The certification ECU (smart key ECU assembly) and the ECM control the vehicle's immobilizer system functions. Immobilizer system data and diagnostic trouble codes (DTCs) can be read from the vehicle's Data Link Connector 3 (DLC3).
In some cases, a malfunction may occur in the immobilizer system even though the security indicator is off.
If the system does not appear to be operating normally, use the Techstream to troubleshoot and repair any malfunctions.
CHECK DLC3
(a) Check DLC3.
Click here![]()
CHECK BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard voltage:
11 à 14 V
If the voltage is below 11 V, charge or replace the battery.
SYMPTOM TABLE FOR STARTING FUNCTION PROBLEMS
Symptom | Suspected Area | Component malfunction | DTCs that may be output | Related Data List Item |
|---|---|---|---|---|
The engine does not start*1 |
Certification ECU (Smart Key ECU Assy) |
Open or short circuit in ECU |
|
|
The engine does not start*1 |
ID Code Box (Immobilizer ECU) |
Open or short circuit in ECU |
|
|
ECM |
Open or short circuit in ECU |
|
EFI Code Receive |
|
SFI System |
ECM incompatible with installed immobilizer system |
B279C |
|
|
It is impossible to change the power source mode*1 |
Engine Switch |
Open or short circuit in switch |
B278A |
|
Certification ECU (Smart Key ECU Assy) |
Open or short circuit in ECU |
|
|
|
Steering lock does not lock/unlock*2 |
Steering lock ECU (steering lock actuator or upper bracket assembly) |
|
|
|
- *1: Refer to the Smart Key System Malfunction Symptom Table (for Start Function).
Click here
.gif)
- *2: Refer to the Malfunction Symptom Table for the steering lock system.
Click here
.gif)