Theft Deterrent / Keyless Entry

The immobiliser system does not operate correctly.

~3min read

DESCRIPTION

The immobiliser system compares the ID code registered in the certification ECU (smart key ECU assembly) with the ID code of the transponder chip built into the electronic key transmitter sub-assembly.

WIRING DIAGRAM

Refer to DTC B2799.

Click here

PRECAUTION / NOTICE / HINT

NOTICE:

  • While using the Techstream with the vehicle engine switch OFF, connect the Techstream to the DLC3 and turn a welcome light switch ON and OFF at intervals of no more than 1.5 seconds until communication between the Techstream and the vehicle starts. Then select the vehicle type in manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, regularly switch a welcome light switch between ON and OFF at intervals of no more than 1.5 seconds to maintain communication between the Techstream and the vehicle.
  • Before replacing the ECM or the ID code box (immobiliser code ECU), refer to the Registration section.

    Click here

  • After completing the repairs, make sure no DTCs are output by performing the "DTC Output Confirmation Operation" procedure.

HINT:

If a DTC of the immobiliser system or the SFI system is output, first perform troubleshooting for the immobiliser system or SFI system DTCs.

PROCEDURE

  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Check the DTCs.

Click here

Body Electrical > Smart Key > Trouble Codes

Result:

Result

Proceed to

No DTCs are output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A
  1. CHECK WHETHER THE ENGINE STARTS

(a) Check that the engine starts 5 seconds after the engine switch is turned to ON (IG).

OK:

The engine starts normally.

OK

USE SIMULATION METHOD TO CHECK

NG
  1. CHECK HARNESS AND CONNECTOR (ID CODE BOX (IMMOBILISER CODE ECU) - ECM)

(a) Disconnect the F21 connector from the ID code box (immobilizer code ECU).

(b) Disconnect the A38 ECM connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F21-3 (EFII) - A38-45 (IMO)

Always

Below 1 Ω

F21-4 (EFIO) - A38-28 (IMI)

Always

Below 1 Ω

F21-3 (EFII) or A38-45 (IMO) - Body ground

Always

10 kΩ minimum

F21-4 (EFIO) or A38-28 (IMI) - Body ground

Always

10 kΩ minimum

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. REGISTER ECU COMMUNICATION ID

(a) Register the ECU communication ID code.

Click here

NEXT
  1. CHECK WHETHER THE ENGINE STARTS

(a) Make sure the engine starts.

OK:

The engine starts normally.

OK

END (COMMUNICATION ID REGISTRATION FAILED)

NG
  1. REPLACE ID CODE BOX (IMMOBILISER CODE ECU)

(a) Replace the ID code box (immobiliser ECU) with a new one.

Click here

NEXT
  1. REGISTER ECU COMMUNICATION ID

(a) Register the ECU communication ID code.

Click here

NEXT
  1. CHECK WHETHER THE ENGINE STARTS

(a) Make sure the engine starts.

OK:

The engine starts normally.

Result:

Result

Proceed to

OK

A

NG (without Fuel Vapor Pump Module Absorber)

B

NG (with Fuel Vapor Pump Module Absorber)

C

A

END (ID CODE BOX (IMMOBILISER ECU) WAS FAULTY)

B

GO TO SFI SYSTEM

C

GO TO SFI SYSTEM