Toyota Corolla Quiz
Body

Glove Box

In this manual: Body
Owner's Manual — 7Controls and Instruments — 49Engine Starting and Vehicle Operation — 5Actions if the Engine Does Not Start — 18Maintenance — 30Gasoline Engines - Repair Procedures Without Engine Removal from Vehicle — 17Gasoline Engines - Removal and Overhaul — 21Diesel Engine — 26Engine Electrical Equipment — 13Cooling and Heating Systems — 17Fuel and Exhaust Systems — 14Emission Control System — 19Manual transmission — 6Automatic transmission — 9Clutch and Axle Shafts — 11Brake System — 20Suspension and Steering — 24Body — 29Electrical System — 24Wiring Diagrams — 24
~1min read

Removal and installation

PROCEDURE

1. Отсоедините провод "массы" от аккумулятора. Отвинтите болты, вытащите бардачок

1. Disconnect the negative battery cable. Remove the bolts, pull the glove box out of the instrument panel and lower it to access the airbag connector.

2. Открепите разъем от держателей и снимите бардачок. (Не отсоединяйте разъем

2. Release the connector from the holders and remove the glove box. (Do not disconnect the airbag connector unless you are removing the airbag module).
3. Installation is performed in the reverse order of removal.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.