Toyota Corolla Quiz
Body

Instrument Cluster Finish Panel

In this manual: Body
Owner's Manual — 7Controls and Instruments — 49Engine Starting and Vehicle Operation — 5Actions if the Engine Does Not Start — 18Maintenance — 30Gasoline Engines - Repair Procedures Without Engine Removal from Vehicle — 17Gasoline Engines - Removal and Overhaul — 21Diesel Engine — 26Engine Electrical Equipment — 13Cooling and Heating Systems — 17Fuel and Exhaust Systems — 14Emission Control System — 19Manual transmission — 6Automatic transmission — 9Clutch and Axle Shafts — 11Brake System — 20Suspension and Steering — 24Body — 29Electrical System — 24Wiring Diagrams — 24
~1min read

* These models are equipped with airbags. The airbag is in a ready state and may deploy at any time if the battery is connected. To avoid accidental deployment (and possible injury), turn the ignition key to the LOCK position and disconnect the negative battery cable whenever working near airbag components. After disconnecting the battery, wait at least two minutes before starting work (the system has a backup capacitor that must fully discharge). For more details, see subsection 12.24.

Removal and installation

PROCEDURE
1. Disconnect the negative battery cable.

2. Отвинтите два болта на верхней части обрамления.

2. Remove the two bolts from the upper part of the finish panel.

3. Отсоедините два зажима на нижних краях, приподняв их при помощи отвертки

3. Disengage the two clips on the lower edges by prying them up with a screwdriver.

4. Крепко зажмите обрамление и снимите его

4. Firmly grasp the finish panel and remove it.
5. Installation is performed in the reverse order of removal.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.