BMW X3 Quiz

Engine and gearbox suspension

In this manual: Engine and gearbox suspension
General information on preservation measures — 1Body cavity sealing — 1Body corrosion protection — 1Body repair instructions — 1Support members — 1Luggage compartment floor — 1Wheel wells — 1Side frame and door pillars — 1Roof outer skin — 1Dash cowl — 1Front trim panel — 1Rear trim panel — 1Side panels — 1Front side doors — 1Rear side doors — 1Front lid — 1Rear lid — 1Other flaps — 1Body special tools — 1General information — 1Handling brake fluids — 1Brake testing and bleeding — 1Front brakes — 1Rear brakes — 1Master brake cylinder — 1Brake lines — 1Brake booster — 1Electrical components/wear indicator — 1Parking brake — 1Mechanical/hydraulic components — 1Electronic components — 1Brakes — 1Front brake — 1Pedal mounting block — 1Brake pedal with linkage — 1Clutch pedal with linkage — 1Accelerator pedal actuation — 1Pedals — 1Specified grease — 1Propeller shaft, general — 1Propeller shaft assembly — 1Center console assembly — 1Front propeller shaft — 1Propeller shaft — 1Propeller shaft complete — 1Front axle repair instructions — 1Front axle suspension — 1Front sub-frame — 1Struts with rubber mounts — 1Wheel bearings and stub axle — 1Spring strut — 1Spring with suspension — 1Stabilizer bar — 1Front axle gearbox — 1Output shaft — 1Front axle — 1General information on high temperature multi-purpose grease — 1Rear axle repair instructions — 1Final drive with cover — 1Final drive mounting — 1Output shafts — 1Rear sub-frame — 1Control arms and struts — 1Axle mounting — 1Wheel bearings — 1Shock absorber — 1With suspension — 1Stabilizer bar — 1Rear axle — 1General information on final drive oil — 1Approved final drive oils for front and rear axle final drives with and without limited slip or viscous coupling — 1Final drive oil for bmw m1 motorsport coupe — 1Operating fluids as of 11/2015 — 1Brake pad replacement reminder — 1Emissions maintenance reminder — 1Maintenance service reminder — 1Tire pressure monitor system reminder — 1Description — 1Troubleshooting — 1Ignition wires, spark plugs — 1Ignition coil — 1Electronic switching or control units — 1Preheating relay — 1Preheater plugs — 1Alternator with drive and mounting — 1Controller — 1Starter with mounting — 1Starter lead — 1Engine wiring loom — 1Oil pressure/oil temperature/oil gauge — 1Switches and relays — 1Engine electrical system — 1Cabin air filter — 1Cabin air filter applications — 1Operating fluids - air conditioning and heating — 1Air conditioner refrigerant — 1Refrigeration oil — 1Note, overview components climate control — 1Heater with operation — 1Auxiliary. heater with control elements — 1Nozzles and outlets — 1Microfilter — 1Air conditioning, leak detection — 1Ac housing/evaporator, switching elements — 1Compressor — 1Condenser and dryer with lines — 1Heating and air conditioning — 1Front axle repair instructions — 1Front axle suspension — 1Front sub-frame — 1Struts with rubber mounts — 1Wheel bearings and stub axle — 1Spring strut — 1Spring with suspension — 1Stabilizer bar — 1Front axle gearbox — 1Front axle — 1General information on high temperature multi-purpose grease — 1Integrated suspension systems repair instructions — 1Front control and suspension elements — 1Rear control and suspension elements — 1Electrical components — 1Electronic damping force adjustment — 1Integrated suspension systems — 1Approved hydraulic fluids — 1Rear axle repair instructions — 1Final drive — 1Final drive with cover — 1Final drive mounting — 1Output shafts — 1Rear sub-frame — 1Control arms and struts — 1Axle mounting — 1Wheel bearings — 1Shock absorber — 1Springs with suspension — 1Stabilizer bar — 1Rear axle — 1General information on final drive oil — 1Approved final drive oils for front and rear axle final drives with and without limited slip or viscous coupling — 1Final drive oil for bmw m1 motorsport coupe — 1Operating fluids as of 11/2015 — 1Electronic chassis alignment — 1Mechanical steering gear — 1Steering gear with servo unit — 1Steering arms, tie rods, steer. damper — 1Steering column — 1Steering wheel — 1Steering wheel for airbag — 1Pump and oil supply — 1Steering and wheel alignment — 1Wheels — 1Disc wheels (rims) — 1Tires — 1Wheels with tires — 1Tire mounting paste — 1Engine mounting — 1Transmission suspension, automatic. transmission — 1Engine and gearbox suspension — 1Transmission in general — 1Transmission case, oil sump — 1Extension housing, bearings, seal — 1Mechanical attachments — 1Hydr/el control components/elements — 1Oil pump — 1Shift valves, parking lock — 1Torque converter — 1Automatic transmission — 1Automatic transmission fluid for zf-transmission GA8HP45Z / GA8HP50Z / GA8HP70Z / GA8HP90Z / GA8P70H / GA8P75H / GA8HP75Z — 1General information on automatic transmission fluids — 1Approved automatic transmission fluids for initial fillings and correcting fluid levels — 1Checking transmission fluid level — 1Transmission fluid change intervals (if applicable) — 1Transfer case, general — 1Transfer box — 1Transmission shafts — 1Transfer box special tools — 1Transfer box in general (atc 45l) — 1Transmission in general — 1Bearing in housing, sealing ring — 1SELF-DIAGNOSTICS DTCS — 1
~5min read
  • Bridge
  • Device
  • Synchronizing key
  • Tool
  • Washer

Bridge

Bridge Minimum set: Mechanical tools AM

NOTE: For pulling out the transfer box rubber mount. Series: E46/16, E83

Storage Location

B9

Transmission

NOTE: Available as part of set of special tools 22 1 040-22 1 040 -> (83 30 0 495 240) only.

Storage Location

B50

Transmission

Bridge AM

NOTE: For removing rubber mount.

Storage Location

C28

Transmission

BUSH

Bush Minimum set: Mechanical tools AM

NOTE: For pulling out the transfer box rubber mount - series: E53, E83, E90

Storage Location

C9

Transmission

Device

Device AM

In conjunction with: 33 4 465/466, 22 1 102, 22 1 046 = 0496792

NOTE: For removing and installing the rubber mount.

Storage Location

C28

SI number

01 03 10 (619)

Consisting of:

Transmission

1. Bridge

NOTE: For removing rubber mount.

2. Washer

NOTE: For removing rubber mount

3. Washer

NOTE: For fitting rubber mount.

Device Minimum set: Mechanical tools AM

NOTE: For removing and installing rubber mount on transfer box: ATC300, ATC350, ATC450

Storage Location

B50

SI number

01 04 05 (175)

Transmission

Consisting of:

1. Bridge

NOTE: Available as part of set of special tools 22 1 040-22 1 040 -> (83 30 0 495 240) only.

2. Holder

NOTE: Available as part of set of special tools 22 1 040-22 1 040 -> (83 30 0 495 240) only.

3. Washer

NOTE: (Thrust washer) Available as part of set of special tools 22 1 040-22 1 040 - > (83 30 0 495 240) only.

4. Washer

NOTE: (Profile washer) Only available via complete tool set 22 1 040 -> (83 30 0 495 240).

5. Washer

NOTE: (Washer with cylindrical pins) Only available via complete tool set 22 1 040 -> (83 30 0 495 240).

6. Washer

NOTE: For installing rubber mount in transfer box housing.

In conjunction with: 22 1 044, 33 4 465/466 = 0495266

HOLDER

Holder Minimum set: Mechanical tools AM

NOTE: Available as part of set of special tools 22 1 040-22 1 040 -> (83 30 0 495 240) only.

Storage Location

B50

Transmission

MOBILE EQUIPMENT TABLE LIFT

Mobile equipment table lift Mechanical tool

NOTE: Table lift Gruse MHT 1200

SI number

06 01 10 (649)

Transmission

NUT

Nut Minimum set: Mechanical tools AM

NOTE: For installing and removing the transfer box rubber mount - series: E46/16

Storage Location

B9

Transmission

Synchronizing key

Synchronizing key Minimum set: Mechanical tools AM

NOTE: For installing the transfer box rubber mount - series: E53

Storage Location

B9

C9

Transmission

Synchronizing key Minimum set: Mechanical tools AM

NOTE: For installing the transfer box rubber mount - series: E46/16, E83

Storage Location

B9

Transmission

Synchronizing key Minimum set: Mechanical tools AM

Replaced by: 83300493807

NOTE: For pulling out the transfer box rubber mount - Replaced by 22 1 018 (0 493 807)

Transmission

Tool

Tool Minimum set: Mechanical tools AM

NOTE: (Tool set) For removing and installing the transfer box rubber mount 22 1 018 for E46/16, E67 and RR

Storage Location

B9

SI number

01 15 99 (483)

Consisting of:

Transmission

3 = Synchronizing key

NOTE: For pulling out the transfer box rubber mount - Replaced by 22 1 018 (0 493 807)

3 = Washer

NOTE: (Support disc) For installing the transfer box rubber mount - series: E53 - Replaced by 22 1 019 (0 493 808)

3 = Synchronizing key

NOTE: For installing the transfer box rubber mount - series: E53

4 = Synchronizing key

NOTE: For installing the transfer box rubber mount - series: E46/16, E83

6 = Bridge

NOTE: For pulling out the transfer box rubber mount. Series: E46/16, E83

5 = Washer

NOTE: Series: E46/16

7 = Nut

NOTE: For installing and removing the transfer box rubber mount - series: E46/16

8 = Bush

NOTE: For pulling out the transfer box rubber mount - series: E53, E83, E90

9 = Washer

NOTE: For installing the transfer box rubber mount - series: E53

10 = Washer

NOTE: For installing the rubber mount in the transfer box-transfer box: ATC400 Model series: E83

Washer

Washer Minimum set: Mechanical tools AM

NOTE: Series: E46/16

Storage Location

B9

C9

Transmission

Washer Minimum set: Mechanical tools AM

NOTE: For installing the transfer box rubber mount - series: E53

Storage Location

C9

Transmission

Washer Minimum set: Mechanical tools AM

NOTE: (Washer with cylindrical pins) Only available via complete tool set 22 1 040 - > (83 30 0 495 240).

Storage Location

B50

Transmission

Washer Minimum set: Mechanical tools AM

In conjunction with: 22 1 044, 33 4 465/466 = 0495266

NOTE: For installing rubber mount in transfer box housing.

Storage Location

B28

SI number

01 25 09 (591)

Transmission

NOTE: For installing the rubber mount in the transfer box-transfer box: ATC400 Model series: E83

Storage Location

C9

Transmission

NOTE: (Thrust washer) Available as part of set of special tools 22 1 040-22 1 040 -> (83 30 0 495 240) only.

Storage Location

B50

Transmission

NOTE: (Profile washer) Only available via complete tool set 22 1 040 -> (83 30 0 495 240).

Storage Location

C50

Transmission

Replaced by: 83300493808

NOTE: (Support disc) For installing the transfer box rubber mount - series: E53 - Replaced by 22 1 019 (0 493 808)

Transmission

Washer AM

NOTE: For removing rubber mount

Storage Location

C28

NOTE: For fitting rubber mount.

Storage Location

C28

ENGINE MOUNTING

TIGHTENING TORQUE SPECIFICATION - ENGINE MOUNTING

Transmission

TRANSMISSION MOUNTING

TIGHTENING TORQUE SPECIFICATION - TRANSMISSION MOUNTING

Transmission
Transmission

Test yourself

A quick BMW X3 quiz: every answer comes with an explanation and a link to the manual page.