Body Electrical System

AVN Head Unit

8steps
~48min
2/5difficulty
Done 0 of 8

Components and Component Location

Components

Connector Pin Information

No. Connector A Connector B Connector C Connector D
Internal Amplifier External amplifier
1 Left rear door speaker (+) - - - Ground
2 Left rear door speaker (-) - MIC (+) - -
3 - Voice navigation amplifier (+) - - Hazard Warning Switch
4 - Amplifier_SPDIF (High) - - Passenger Seat Belt Reminder
5 - Antenna Power - -
6 RVM Camera: Power Illumination (+) - Indicator / PAB Off
AVM Camera: -
7 RVM Camera: Video Multimedia CAN (High) - IGN1
AVM Camera: Video (Y)
8 RVM Camera: - Monitor board_enable - PAB On
AVM Camera: Video (C)
9 - - - -
10 AUX Audio right_input Battery (+) - -
11 AUX Detection Battery (+) - -
12 Steering Wheel Remote Control Key Ground - Hazard Lamp
13 Left front door speaker (+) - Ground -
14 Left front door speaker (-) - MIC Ground -
15 Right front door speaker (-) - MIC (-) -
16 Right front door speaker (+) - RVM Camera: - -
AVM Camera: Equipment_Detect -
17 - Voice navigation amplifier (-) - -
18 - Amplifier SPDIF (Low) - -
19 - SPDIF Amplifier (Ground) Illumination (-) -
20 RVM Camera: Ground Multimedia CAN (Low) -
AVM Camera: - -
21 RVM Camera: Video Ground Display_Mute -
AVM Camera: Video (Y) Ground
22 RVM Camera: - ACC
AVM Camera: Video (C) Ground
23 - -
24 AUX Audio Left Input LCD Battery
25 AUX audio ground -
26 Steering Wheel Remote Control (Ground) -
27 Right rear door speaker (-) - -
28 Right rear door speaker (+) - -
29 - -
30 - -
31 - -
32 RVM Camera: - -
AVM Camera: Equipment_Detect -
33 RVM Camera: - IGN1
AVM Camera: Video Screen (Y)
34 RVM Camera: - -
AVM Camera: Video Screen (C)
35 - LCD Ground
36 -
37 -
38 Vehicle Speed

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the heater and A/C control unit.

    (Refer to Heating, Ventilation and Air Conditioning - Heater and Air Conditioner Control) Unit (DATC)")

  3. Remove the passenger side airbag side panel.

    (Refer to Body - "Center Crash Pad Panel")

  4. Remove the AVN head unit (A) after loosening the mounting screws.

  5. Remove the AVN head unit after disconnecting the connectors and the antenna cable (A).

Installation

  1. Install the AVN head unit after connecting the connectors and cable of the AVN head unit.

  2. Install the passenger side panel.

  3. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.