Kia Stinger CK Quiz
Body Electrical System

AVN Remote Control

In this manual: Body Electrical System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
20steps
~120min
4/5difficulty
Done 0 of 20

Components and Component Location

Components

1. Left Remote Control Switch
(Audio + Bluetooth + Voice)		 2. Right Remote Control Switch
(Trip Computer + ACC + SCC)

Circuit Diagrams

Wiring Diagram

[Audio + Bluetooth + Voice]

[Trip + ACC]

[Trip + ACC + SCC]

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the steering wheel assembly.

    (Refer to Steering System - "Steering Wheel")

  3. Remove the steering wheel switch (A) after loosening the mounting screws.

    [LH]

    [RH]

  4. Disconnect the connector of the steering wheel switch (A).

    [LH]

    [RH]

  5. Remove the steering wheel front cover (A) after loosening the mounting screws.

  6. Remove the steering wheel rear cover (A) after loosening the mounting screws.

  7. Remove the steering wheel rear cover (A) after loosening the mounting screws.

  8. Disconnect the remote control connector on the steering wheel (A).

    [LH]

    [RH]

  9. Remove the remote control switch from the steering wheel (A) after loosening the mounting screws.

    [LH]

    [RH]

Installation

  1. Install the remote control switch on the steering wheel.

  2. Connect the remote control switch connector on the steering wheel.

  3. Install the steering wheel rear cover.

  4. Install the steering wheel rear cover.

  5. Install the steering wheel front cover.

  6. Connect the steering wheel switch connector.

  7. Install the steering wheel switch.

  8. Install the steering wheel assembly.

  9. Connect the negative (-) battery terminal.

Inspection

  1. Check the resistance between terminals at each switch position (LH).

    [L: Audio + Bluetooth + Voice]

    Switch Connector
    Terminal    		 Resistance
    (±3%)
    SEEK UP 1-6 430 Ω
    SEEK DOWN 1.11 kΩ
    MODE 2.11 kΩ
    MUTE 3.11 kΩ
    VOL (+) 4.61 kΩ
    VOL (-) 6.81 kΩ
    Voice 10.71 kΩ
    END 18.91 kΩ
    SEND 40.91 kΩ

  2. Check the resistance between terminals at each switch position (RH).

    [R: Trip + ACC + SCC]

    Switch Connector
    Terminal    		 Resistance
    (±3%)
    Cancel 2-6 390 Ω
    SET - 610 Ω
    VOICE + 910 Ω
    CRUISE ON/OFF 1.38 kΩ
    Cruise and Speed Limiter ON/OFF 2.13 kΩ
    SCC (Smart Cruise Control) 3.63 kΩ
    GROUP 1-6 390 Ω
    STEP 610 Ω
    TRIP DOWN 910 Ω
    ENTER 1.38 kΩ

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.