Theft Deterrent / Keyless Entry

Vehicle Submersion Detection (B2277)

~3min read

DESCRIPTION

This DTC is stored when a malfunction is detected in the water immersion detection circuit of the certification ECU (smart key ECU assembly).

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Note

B2277

Vehicle Submersion Detection

Water immersion detected by the water immersion detection circuit of the certification ECU (smart key ECU assembly). (1 trip detection logic*)

Certification ECU (Smart Key ECU Assy)

  • Wait 300 seconds after connecting the cable to the negative (-) battery terminal.
  • *: Detected only when a malfunction is identified.
Vehicle Condition and Fail-Safe Function When Malfunction Is Detected

Vehicle Condition When Malfunction Is Detected

Fail-Safe Function When Malfunction Is Detected

The engine switch cannot be turned OFF and the engine cannot be started.

-

Related Data List and Active Test Items

DTC No.

Data List and Active Test

B2277

-

PRECAUTION / NOTICE / HINT

NOTICE:

  • While using the Techstream with the vehicle engine switch OFF, connect the Techstream to the DLC3 and turn a welcome light switch ON and OFF at intervals of no more than 1.5 seconds until communication between the Techstream and the vehicle starts. Then select the vehicle type in manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, regularly switch a welcome light switch between ON and OFF at intervals of no more than 1.5 seconds to maintain communication between the Techstream and the vehicle.
  • The smart key system (for engine start function) uses the LIN communication system and the CAN communication system. Check the communication function by following the procedure in the HOW TO USE TROUBLESHOOTING section. Troubleshoot the smart key system (for entry function) only after confirming that the communication systems are operating properly.

    Click here

  • Before replacing the certification ECU (smart key ECU assembly), refer to the precautions for the smart key system (for engine start function).

    Click here

  • After repair, make sure no DTCs are output by performing the "DTC Output Confirmation Operation" procedure.

HINT:

  • Before troubleshooting, make sure there are no signs of water damage to the certification ECU (smart key ECU assembly). If there are signs of water damage, replace the certification ECU (smart key ECU assembly) and take the necessary measures against the cause of the water damage.
  • When the cable is disconnected and then reconnected to the negative (-) battery terminal, the power source mode does not return to the state selected before the cable was disconnected.

PROCEDURE

  1. CHECK FOR WATER INTRUSION

(a) Check that the certification ECU (Smart Key ECU Assembly), its surrounding area and the wire harnesses show no signs of water intrusion.

Result:

Result

Proceed to

No signs of water intrusion found

A

Signs of water intrusion found

B

A

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSY)

B

CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)